What do you think?
An Introduction to Measuration and Calibration
Provides illustrations of the devices throughout with descriptions of how they are used in industry. Offers a vast amount of new material that can be applied to virtually any imaginable measurement or calibration task.
208 pages, Paperback
First published January 1, 1995
Ratings & Reviews
Friends & Following
Create a free account to discover what your friends think of this book!
Community Reviews
Displaying 1 - 1 of 1 review
October 14, 2019
The book is only 166 pages long, but it unfortunately hasn’t been updated to keep up with technology. Loads of the material is on machines from what seems like the 70’s or 80’s. Even my metrology teacher said that the book is obsolete and that the school is going to a new book for the class the next time it’s taught. So what was the point in even reading it?! The stuff I was required to read I already knew about 75%+ of it from actual physical use in years prior. It almost seems the entire class and book was a waste of time. The little bit I didn’t know I could’ve looked up on Wikipedia.
Displaying 1 - 1 of 1 review