Christopher Neal's Blog
March 11, 2015
Hello there!
So its been a while since I have posted last, so here is where I am at! I finished the book last October and have since then taken it back into being edited. A process which was just completed, and now the book is better than ever! :) I am going to post the first few chapters here, so feel free to comment and critique in the comments! :)
Published on March 11, 2015 17:40
October 25, 2014
Createspace Blessing or Curse?
I am currently learning about Print On Demand with Createspace. I just spent two hours learning about margins and how much I didn't know. I finally figured out about "gutter margins" and "bleeding" so much I feel like I am actually bleeding in a gutter. Anyway, in a couple of days I should have an actual hold in your hands, get a paper cut from, physical copy of by book. Worth every frustrating formatting issue.
Published on October 25, 2014 01:48
August 12, 2014
Little sneak peak into the new book! Tuning In
Little sneak peak into the new book! Tuning In
Published on August 12, 2014 22:07
Little sneak peak into the new book! Tuning In
Little sneak peak into the new book! Tuning In
Published on August 12, 2014 22:07
The book is done!!!
After many long hours the book is complete! Let the series "Dancing to a New Tune" begin!
Published on August 12, 2014 21:58
January 6, 2014
Right now I am learning about self-publishing. I have rea...
Right now I am learning about self-publishing. I have read Jennifer Ciotta's "No Bulls**t Guide to Self-publishing and found it quite informative. I am also learning how to use Goodreads. To bad being good looking, and charismatic isn't enough. I have a ton to learn.
Published on January 06, 2014 15:59
December 10, 2013
Start Your Engines
Okay, this is exciting. I have just submitted my book "Tuning In" to an editor. What would you do if you could hear a person's thoughts and were raised by a family of crooks. A family of crooks with morals and a great love of revolution against "the man." What type of person would you be?
Published on December 10, 2013 17:25


